You should follow these instructions if your drive has no parallel capabilities yet and you want to create a parallel port on your drive and then connect the cable to it. This is the more elegant method.

Important notes

• On circuit diagrams, plugs are displayed as viewed from the back side, the solder side. Chips are displayed as viewed from above; also, see the small semicircular cut for finding the correct orientation. When in doubt, see the corresponding description on the legend page.

Construction

First, create the parallel port for 1541 drives or the parallel port for 1570 and 1571 drives.

You need the following parts to build this cable:

• One solderable 15-pin male plug (PC game plug)

• One solderable user port plug

• A shielded or unshielded 10-wire cable of, preferably, at most 2 meters

Step 1. Take the long cable and solder one end of it onto the game plug.

Step 2. Solder the other end of the cable onto the user port plug. You should have the following connections:

   Game plug   
User port plug 

        1      
    C, PB0     

        2      
    D, PB1     

        3      
    E, PB2     

        4      
    F, PB3     

        5      
    H, PB4     

        6      
    J, PB5     

        7      
    K, PB6     

        8      
    L, PB7     

        9      
    8, PC2     

       10      
    B, FLAG2   

 not connected 
    A, GND     

Circuit diagram

You can find the description of all parts used on the diagrams at the legend page.

Contact | Copyright and license | Blog page | Recent updates | Title page
(This page best viewed with any browser)