Important notes

• On circuit diagrams, plugs are displayed as viewed from the back side, the solder side. Chips are displayed as viewed from above; also, see the small semicircular cut for finding the correct orientation. When in doubt, see the corresponding description on the legend page.

Construction

You need the following parts to build this cable:

• Two solderable 6-pin male DIN plugs (Commodore serial plugs)

• A shielded 5-wire or unshielded 6-wire cable of, preferably, at most 2 meters

Step 1. Solder one end of the cable onto one DIN plug.

Step 2. Solder the other end of the cable onto the other DIN plug. You should have the following connections:

   DIN plug    
   DIN plug    

    1, SRQ     
    1, SRQ     

    2, GND     
    2, GND     

    3, ATN     
    3, ATN     

    4, CLK     
    4, CLK     

    5, DATA    
    5, DATA    

    6, RESET   
    6, RESET   

Circuit diagram

You can find the description of all parts used on the diagrams at the legend page.

Contact | Copyright and license | Blog page | Recent updates | Title page
(This page best viewed with any browser)