On circuit diagrams, plugs are displayed as viewed from the back side, the solder side. Chips are displayed as viewed from above; also, see the small semicircular cut for finding the correct orientation. When in doubt, see the corresponding description on the legend page.
You need the following parts to build this cable:
One solderable 8-pin male DIN plug
Four solderable male RCA plugs, preferably, in red, black, yellow and white colors
Four shielded 1-wire cables of, preferably, at most 2 meters each; the impendance should be 75 Ohm but an audio cable should also work
Step 1. Solder one end of each cable onto the DIN plug.
Step 2. Solder the other ends of the cables onto the tip of each of the four RCA plugs. You should have the following connections:
|DIN plug|| RCA plug |
|1, Luminance|| Black |
|3, Audio Out|| White |
|4, Video Out|| Yellow |
|6, Chrominance|| Red |
Step 3. Connect pin 2 (GND) of the DIN plug to the outer ring of all four RCA plugs.
You can find the description of all parts used on the diagrams at the legend page.
Copyright and license |
Blog page | Recent updates |
(This page best viewed with any browser)